Some users have luck with just pulling the power and booting up the hotspot again, while others have to end up contacting Bobcat support and have them connect to the hotspot and fix things up. Your mobile hotspot not working Windows 11 issue should be resolved now. Follow on-screen prompts to run the network adapter troubleshooter. In the troubleshooter’s window, select the All network adapters radio button and click Next. This can be caused by a bad firmware update and/or snapshot. Hit the Run button located next to Network Adapter. The most common cause I’ve seen is that the miner software fails to start, causing the hotspot to reboot and try again. If you see it cycling between red, yellow and green, this typically means the hotspot is stuck rebooting. If you’re having issues with the hotspot it’s a good idea to keep an eye on the hotspot to make sure the LED stays green. Ideally, the LED should be green which indicates the hotspot is booted and the miner software is running. The hotspot has a LED that indicates the current state of the hotspot. This might include network connectivity errors or other critical issues that need to be resolved. If your hotspot mining software is having any issues chances are the error will be listed here. Scrolling all the way to the bottom you see an error section. Scrolling further down we see a helpful summary showing that our hotspot is connected to the Helium Peer-to-peer network and that port forwarding is in order, as evidenced by the nat_type value of ‘none’.
0 Comments
Leave a Reply. |